Practical Advice About Bandsaw Gear
As with every one of shop gear there are measures that if followed will expand the days of both your jet bandsaw and the cutting blade. Suitable tension, feed force, regular clean-up, and lubrication are all required to get the most from this equipment.
There are specific safety measures to be taken in order to guard the blades from premature wearing. For example, while the blades are new, they are exceedingly razor-sharp, and any hard deed on it will cause spoil to its teeth.
In order to stay away from hasty wear, manufacturers suggest a break-in action for new saw blades. This can be done by reducing the speed of sawing in the opening period, often to half of the standard rate. Reducing the feed amount in the beginning, approximately for the first 50 square inches of the items, will as well help to rub off the extra sharpness of the blade and will make it more durable.
Even if you don’t know what the typical feed pressure for the stuff should be, to be safe, begin with a gentle feed, and at a snail’s pace increase the feed force until proper curly chips (in metal) or chip sizes (for wood) are shaped. Be awake that there are particular alloys such as ones that are nickel-based which are sawed below minor speeds and so necessitate additional break-in force.
Lubrication is a have to for band saw blades cutting metal. By no means apply water as a lubricant or a cleaning instrument as it will bring about rusting and chunk the easy execution of the blades. A suitable lubricant will be a mixture of one amount of High Adhesion Chain Saw Bar oil with partially amount of kerosene or diesel. Use the mix on both sides of the cutting edge.